200 Watt AC to DC Switchers Enhanced EMI Performance AM200EC

200 Watt AC To DC Converter

  • Power Factor Correction
  • Fully Compliant with MIL-STD-461, CE101, CE102
  • Meets MIL-S-901 (High Impact Shock)
  • Meets MIL-STD-810
  • FCC 20780 class A EMI compliance
  • Sealed to meet IP67
  • Condensing environment option available

AC INPUT:
95 to 260 VAC, 47-440Hz, single phase.
Power factor corrected. Meets MIL-STD-1399, Section 300, type 1 requirements

EFFICIENCY:
80% minimum

LINE REGULATION:
±1% of nominal over the full range of line input voltage.

LOAD REGULATION:
±1% for change from no load to full load.

RIPPLE AND NOISE:
Peak-to-peak combined ripple and noise does not exceed 2% of nominal output measured with a 20MHz bandwidth.

OPERATING TEMPERATURE RANGE:
-50°C to +85°C Baseplate, Operating temperature: -40°C to +70°C baseplate with no power derating.

ISOLATION:
Input to Output 1500 VDC
Input to Case 1500 VDC
Output to Case 500 VDC

CIRCUIT PROTECTION:
Each unit is completely protected against a short circuit of any duration. The current is nominally set at 120% of full load. The output voltage automatically restores to normal when the short is removed.

WEIGHT:
2 lbs typical.

ENVIRONMENTAL CONDITIONS:
Shock test: Unit meets MIL-S-901 requirements (light weight)

Vibration test: Unit meets MIL-STD-167 , type 1 requirements

Humidity: Power supply operates without any evidence of degraded performance in non-condensing relative humidity up to 95% (select “C” option for 100% condensing environment).

PDF